Stuart-turner S1.5 bar Twin Manual de usuario

Installation, Operation & Maintenance InstructionsPlease leave this instruction booklet with the owner as it contains important guarantee, mainten

- 10 -Cont ...3.12 Hose to pipework: 1. The hoses are fitted with plastic push-in connectors, which must only be connected with the foll

- 11 -Cont ...Fig. 1122 mm Inlet pipework fed from water storage system.22 mm Copper outlet pipeworkIn the case of horizontal feeds use a 15 mm compa

- 12 -4 ELECTRICAL INSTALLATION / EARTHING4.11 Regulations: The electrical installation must be carried out in accordance with the current na

- 13 -Cont ...4.21 Fuse: The following fuse size should be used with the appropriate pump:Model Fuse Size (AMPS)All Models 34.22 Internal WiringDo

- 14 -Cont ...5 COMMISSIONING5.11 System Flushing: This pump incorporates push-in connectors and plastic components that must not come into con

- 15 -Cont ...6 MAINTENANCE  Do not remove the terminal box cover. This is a non serviceable pump. 6.11 Water scale: As water is heated scale d

- 16 -Cont ...7 TECHNICAL SPECIFICATIONStuart Turner reserve the right to amend the specification in line with its policy of continuous development of

- 17 -Cont ...8 TROUBLE SHOOTING GUIDE8.11 Environment Protection: Your appliance contains valuable materials which can be recovered or recycled

- 18 -9 THE TECHFLO tp GUARANTEECongratulations on purchasing a Stuart Turner pump. We are confident this pump will provide many years of trouble fre

- 19 -Installers – Register with Stuart Turner and move up to Approved Installer statusWe receive thousands of enquiries every month from people seeki

- 2 -PRODUCT DESCRIPTIONElectric motor driven single or twin ended centrifugal pump complete with an automatic control system, consisting of flow swit

DECLARATION OF CONFORMITY2006/42/ECBS EN ISO 12100-1, BS EN ISO 12100-2, BS EN 8092006/95/ECBS EN 60335-1, BS EN 60335-2-412004/108/ECBS EN 55014-1, B

- 3 -Cont ...CHECKLISTYour product may vary slightly from the picture above.The quantities shown above are for twin pumps, (single pumps are shown in

- 4 -Cont ...1 READ BEFORE COMMENCING PUMP INSTALLATIONA. Water storage capacity.1.11 The hot and cold water storage capacity must be sufficient to

- 5 -2 LOCATION - GENERAL2.11 Access: For emergencies and maintenance the pump must be easily accessible.2.12 Protection: The pump must be locat

- 6 -Cont ...2.26 Non-Preferred Pump Location: The pump must be located with at least 0.5 metre flooded suction at all times. If it is not pos

- 7 -Cont ...2 LOCATION - TWIN PUMP2.27 The cold water supply: Must be a DEDICATED AIR FREE supply via a tank connector, and must be positione

- 8 -Cont ...Hot water connection:2.29 Hot water cylinder or storage tank: When a hot water cylinder or storage tank is used, ensure the pipewor

- 9 -Cont ...3 PUMP CONNECTIONS  Do not use stainless steel, chrome or nickel plated pipe with the flexible hose push-in plumbing connections.